skip to content

information relative au produit

Système d’anémométrie thermique

Demander un Devis Accessoires Composants Requis


Product Details

(*Cette page est uniquement disponible en anglais.)

Thermal anemometry is a technique requiring a sensor to measure velocity at a single point with high accuracy and high frequency response. A typical thermal anemometry system has three major components, the IFA-300 Constant Temperature Anemometer (CTA), the sensor and the ThermalPro software. There are many different types of sensors, wire or film, for 1D, 2D, and 3D velocity components, and for gaseous and liquid flows. The thermal anemometry system is an excellent tool for turbulent flow because of its high frequency response to measure the fluctuation of the flow and many versions of sensors used in different flow environments.   

A typical Thermal Anemometry system is made up of the following components:

  • IFA 300 Constant Temperature Anemometer
  • Multichannel digitizer
  • ThermalPro Data Acquisition and Analysis software
  • Hot Wire/Hot film sensor(s)

Features and Benefits 

  • SmartTune automatic Bridge optimization technology for accurate flow measurement and ease of use in the operation system
  • Fully computer controlled through the ThermalPro software package
  • Single Point accurate measurement with sensor for velocity range from cm/s to hundreds of m/s
  • Ultra low noise circuit, high spatial resolution and high frequency response up to a few hundred kHz
  • 1, 2 and 3 components of velocity with proper sensor type
  • Even time sampling with high sampling rate for Power spectrum and statistics of flows
  • Optional integrated calibration system

Thermal Anemometry Visual

 

IFA-300 Constant Temperature Anemometer

The IFA 300 Constant Temperature Anemometer (CTA) is a state-of-the-art research anemometer capable of meeting the most demanding measurement requirements. It represents the depth of design capability and an understanding of the dynamics of constant temperature anemometry which TSI has developed over the past fifty years of building exceptional anemometry products.  The anemometer, along with the ThermalPro Data Acquisition and Analysis software provides automatic tuning of the sensor(s) to provide accurate measurements of high speed flows (gas or liquid) and measurement of very low turbulence intensities, for your applications.

The IFA-300 unit comes with a single CTA channel, when multiple channels are needed, additional CTA can be purchased (up to 8 channels of CTA). If more than 8 channels are required for your flow research, an IFA 300 auxiliary cabinet is also required. This allows a total of 16 channels to be configured.

ThermalPro Data Acquisition and Analysis Software

The IFA 300 is designed for complete computer control through the ThermalPro software. System operating functions, such as control of the overheat ratios and signal conditioner settings, are handled via an RS232 interface, while the high speed analog data from the anemometer output is managed with a high speed multichannel digitizer installed inside the computer. The ThermalPro software is supplied with the IFA 300 system to allow all control and data acquisition, data analysis and presentation of results.

 

 

 


    Composants Requis

    If you are seeing this, then the pnlEUCookieScripts is working